Safety, Children in the vehicle – Mercedes-Benz CLS-Class 2015 User Manual

Page 69

Advertising
background image

restraint systems are installed on the left and

right rear seats.
Non-LATCH-type (ISOFIX) child seats may

also be used and can be installed using the

vehicle's seat belt system. Install the child

seat according to the manufacturer's instruc-

tions.

Top Tether

Introduction

Top Tether provides an additional connection

between the child restraint system secured

with a LATCH-type (ISOFIX) child seat mount

and the vehicle. This helps reduce the risk of

injury even further. If the child restraint sys-

tem is equipped with a Top Tether belt, this

should always be used.

Important safety notes

G

WARNING

If the rear seat backrests are not locked, they

could fold forwards in the event of an acci-

dent, heavy braking or sudden changes of

direction. As a result, child restraint systems

cannot perform their intended protective

function. Rear seat backrests that are not

locked can also cause additional injuries, e.g.

in the event of an accident. This poses an

increased risk of injury or even fatal injury.
Always lock rear seat backrests after instal-

ling a Top Tether belt. Observe the lock veri-

fication indicator. Adjust the rear seat backr-

ests so that they are in an upright position.

If the rear seat backrest is not engaged and

locked, this will be shown in the multifunction

display in the instrument cluster. A warning

tone also sounds.

Top Tether anchorages

The Top Tether anchorage points are located

in the rear compartment behind the head

restraints.

X

Move head restraint : upwards.

X

Fold up cover ; of Top Tether anchorage

=.

X

Install the LATCH-type (ISOFIX) child

restraint system with Top Tether. Always

comply with the child restraint system

manufacturer's installation instructions

when doing so.

X

Route Top Tether belt A under head

restraint : between the two head restraint

bars.

X

Hook Top Tether hook ? into Top Tether

anchorage =.

X

Make sure that Top Tether belt A is not

twisted.

X

Tension Top Tether belt A. Always comply

with the child restraint system manufactur-

er's installation instructions when doing so.

X

Fold down cover ; of Top Tether anchor-

age =.

X

Move head restraint : back down again

slightly if necessary (

Y

page 109).

Make sure that you do not interfere with the

correct routing of Top Tether belt A.

Children in the vehicle

67

Safety

Z

Advertising