Comand, Navigation – Mercedes-Benz SL-Class 2014 Owners Manual User Manual
Page 334
If the vehicle is not on a digitized road, the
following is displayed:
R
the linear distance to the destination
R
the direction to the destination
R
the
Off Mapped Road
Off Mapped Road
message
Option 2 – route guidance is already
active: if route guidance is already active, a
prompt will appear asking whether you wish
to terminate the currently active route
guidance.
X
Select
Yes
Yes
or
No
No
and press W to confirm.
If you select
Yes
Yes
, COMAND will stop route
guidance and start route calculation for the
new destination.
If you select
No
No
, COMAND will continue
with the active route guidance.
i
Route calculation takes a certain amount
of time. The time depends on the distance
from the destination, for example.
COMAND calculates the route using the
digital map data.
The calculated route can differ from the
ideal route, for example because of
incomplete map data. Please also refer to
the notes about the digital map
(
Y
page 380).
Entering and saving your home address
You can either enter your home address for
the first time (option 1) or edit a previously
stored home address (option 2).
X
Option 1: enter the address, e.g. a city,
street and house number (
Y
page 327).
X
Once you have entered the address, select
Save
Save
in the address entry menu by turning
cVd and sliding ZVÆ the COMAND
controller and press W to confirm.
X
Select
Save as "My Address"
Save as "My Address"
and press
W to confirm.
COMAND stores your home address under
the
My Address
My Address
entry in the destination
memory.
X
Option 2: proceed as described under
"Option 1".
A prompt appears asking whether the
current home address should be
overwritten.
X
Select
Yes
Yes
and press W to confirm.
After selecting
Yes
Yes
, the
Saving
Saving
Procedure/Successful
Procedure/Successful
message
appears.
Selecting a destination from the
destination memory (e.g. My address)
Introduction
The destination memory always contains an
entry named "My Address". You may wish to
assign your home address to this entry, for
example (
Y
page 332), and select it for route
guidance. This entry is always located at the
top of the list in the destination memory.
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select
From Memory
From Memory
and press W to
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
332
Navigation
COMAND