Mercedes-Benz GL-Class 2012 Owners Manual - Manual (Page 320)

X Open flap ;.
X Pull connector A with the cable and hose
B out of the housing.
X Screw hose B onto flange C of tire
sealant bottle :.
X Insert tire sealant bottle : head
downwards into recess = of the tire
inflation compressor.
X Remove the cap from valve E on the faulty
tire.
X Make sure pressure release screw F on
pressure gauge G is fully closed.
X Screw filler hose D onto valve E.
X Insert connector A into the socket in the
footwell of the second row of seats
(
Y page 286).
! None of the other sockets or cigarette
lighters are designed for operating the tire
inflation compressor.
X Turn the SmartKey to position
1(
Y page 149) in the ignition lock.
X Press on/off switch ? on the tire inflation
compressor to
I.
The tire inflation compressor is switched
on. The tire is inflated.
i First, TIREFIT is pumped into the tire. The
pressure can briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the tire inflation
compressor during this phase.
X Allow the tire inflation compressor to run
for five minutes. The tire should then have
attained a pressure of at least 180 kPa
(1.8 bar/26 psi).
! Do not operate the tire inflation
compressor for longer than eight minutes
at a time without a break. It may otherwise
overheat.
The tire inflation compressor can be
operated again once it has cooled down.
If a pressure of 180 kPa (1.8 bar/26 psi) has
been achieved after five minutes, see
(
Y page 320).
If a pressure of 180 kPa (1.8 bar/26 psi) has
not been achieved after five minutes, see
(
Y page 319).
TIREFIT kit version 2
318
Flat tire
Breakdown assistance