Lane tracking package, Driving and parking, Driving systems – Mercedes-Benz C-Coupe 2012 Owners Manual User Manual

Page 172

Advertising
background image

The functionality of ATTENTION ASSIST is
restricted and warnings may be delayed or
not occur at all:

R

if the road condition is poor, e.g. if the
surface is uneven or if there are potholes

R

if there is a strong side wind

R

if you have adopted a sporty driving style
with high cornering speeds or high rates of
acceleration

R

if you predominantly drive at speeds under
50 mph (80 km/h) or over 112 mph
(180 km/h)

R

if you are currently using COMAND or
making a telephone call with it

R

if the time has been set incorrectly

R

in active driving situations, such as when
you change lanes or change your speed

Warning and display messages in the

multifunction display

X

Activate ATTENTION ASSIST using the on-
board computer (

Y

page 193).

Symbol : appears in the multifunction
display.

If ATTENTION ASSIST is active, you will be
warned no sooner than 20 minutes after your
journey has begun. You will then hear an
intermittent warning tone twice, and the

Attention Assist: Drowsiness

Detected

message appears in the

multifunction display.

X

If necessary, take a break.

X

Press a to confirm the message.

On long journeys, take regular breaks in good
time to allow yourself to rest properly. If you
do not take a break and ATTENTION ASSIST
still detects typical indicators of fatigue or

increasing lapses in concentration, you will be
warned again after 15 minutes at the earliest.
ATTENTION ASSIST is reset when you
continue your journey and starts assessing
your tiredness again if:

R

you switch off the engine.

R

you take off your seat belt and open the
driver's door, e.g. for a change of drivers or
to take a break.

Lane Tracking package

General notes

The Lane Tracking package consists of Blind
Spot Assist (

Y

page 170) and Lane Keeping

Assist (

Y

page 172).

Blind Spot Assist

Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from speeds of
approximately 20 mph (30 km/h). A warning
display in the exterior mirrors draws your
attention to vehicles detected in the
monitored area. If you then switch on the
corresponding turn signal to change lane, you
will also receive an optical and audible
collision warning. Blind Spot Assist uses
sensors in the rear bumper for monitoring
purposes.

G

WARNING

Blind Spot Assist is only an aid designed to
assist driving. It may fail to detect some
vehicles and is no substitute for attentive
driving.
Blind Spot Assist cannot detect road and
traffic conditions. It may fail to detect narrow
vehicles, such as motorcycles or bicycles, or
may only detect them too late.
Monitoring may be affected by dirty sensors,
strong spray or poor visibility caused by snow,

170

Driving systems

Driving and parking

Advertising
This manual is related to the following products: