Mercedes-Benz M-Class 2011 Owners Manual - Manual (Page 118)

X Switch off the lights.
X Open the cargo compartment.
X Open the side trim panel ( Y page 114).
X Turn the corresponding bulb holder
counter-clockwise and remove it.
X Remove the bulb from the bulb holder.
X Insert the new bulb into the bulb holder.
X Insert the bulb holder and turn it clockwise.
X Close the side trim panel ( Y page 114).
License plate lamp
X Switch off the lights.
X Open the tailgate.
X Remove screws :.
X Remove the license plate lamp.
X Replace the bulb.
X Insert the license plate lamp.
X Replace and tighten screws :.
Setting the headlamps
: V vertical axis
;
H (horizontal) height, measured from the
center
Setting the headlamps correctly is extremely
important. Setting the high-beam headlamps
also sets the low-beam headlamps. (The term
headlamps covers both high and low beam.)
To check and adapt the headlamp setting,
proceed as follows:
X Park the vehicle on level ground at a
distance of 25 feet (7.6 m) from a wall or
similar.
X Make sure that the vehicle load is in the
normal range.
X Switch on the L low-beam headlamps.
If the light of the headlamps is not distributed
as shown in the illustration above, follow the
instructions below:
X Open the hood ( Y page 282).
The adjustment screws are located under the
cover.
116
Changing bulbs
Lights and windshield wipers
BA 164.1 USA, CA Edition B 2011; 1; 2, en-US
d2mskot
Version: 3.0.3.5
2010-04-21T17:25:06+02:00 - Seite 116