Mercedes-Benz M-Class 2011 Owners Manual - Manual (Page 91)

! Do not forget that the weather can
change abruptly. Make certain that the
sliding sunroof is closed when you leave the
vehicle. The vehicle electronics can be
damaged if water enters the vehicle
interior.
i Resonance noises can occur in addition
to the usual airflow noises when the sliding
sunroof is open. They are caused by minor
pressure fluctuations in the vehicle interior.
Change the position of the sliding sunroof
or open a side window slightly to reduce or
eliminate these noises.
Operating the sliding sunroof
Opening and closing
i You can still operate the tilt/sliding
sunroof even if you switch off the engine or
remove the SmartKey. This function
remains active for five minutes or until one
of the front doors is opened.
Overhead control panel
:
To raise
; To open
=
To close
X Switch on the ignition.
X Push or pull the 2 switch in the
corresponding direction.
i If you press the 2 switch beyond the
point of resistance, an automatic opening/
closing process is started in the
corresponding direction. You can stop
automatic operation by pressing again.
Automatic opening/raising is only available
if the tilt/sliding sunroof is in the closed
position.
You can open/close the cover for the
sunblind manually when the tilt/sliding
sunroof is raised/closed.
Resetting
Reset the tilt/sliding sunroof if it does not
open smoothly, or if the battery has been
disconnected or has become discharged.
! Contact a qualified specialist workshop if
the tilt/sliding sunroof cannot be closed
fully or reset.
X Remove the SmartKey from the ignition
lock or turn to position
0 (KEYLESS-GO).
X Remove the fuse for the tilt/sliding sunroof
from the main fuse box. To find out where
the fuse is located, refer to the fuse
allocation chart in the vehicle tool kit
(
Y page 298).
X Reinsert the fuse.
X Switch on the ignition.
X Raise the tilt/sliding sunroof fully at the
rear (
Y page 89).
X Keep the 2 switch pressed for another
second.
X Make sure that the tilt/sliding sunroof can
be opened or closed fully again using the
opening/closing process (
Y page 89).
X If the tilt/sliding sunroof can be raised fully
at the rear it is set correctly. If this is not
the case, you must repeat the previously
described steps.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
Sliding sunroof
89
Opening and closing
BA 164.1 USA, CA Edition B 2011; 1; 2, en-US
d2mskot
Version: 3.0.3.5
2010-04-21T17:25:06+02:00 - Seite 89
Z