Mercedes-Benz C-Class 2008 COMAND Manual - Manual (Page 123)

122
Navigation
Introduction
̈ To exit menu: Slide o m p .
̈ Hide menu system if applicable
(
୴ page 119).
Route mode
This functions allows you to set the follow-
ing options for route guidance:
ț “Avoid Highways”
ț “Avoid Toll Roads”
ț “Avoid Tunnels”
ț “Avoid Ferries”
ț “Avoid AutoTrains”
1 Sets route options
Setting route options
̈ To set: Display menu system if applica-
ble (
୴ page 119).
̈ Select “Navi” K “Mode”.
̈ To switch option on/off: Select re-
quired option.
Depending on the previous status, the
option will be switched on
D or off C.
You may activate several options.
i
The calculated route may include ferry con-
nections, for example, even if the option “Avoid
ferries” has been activated.
i
If you change the route type setting when
route guidance is active, COMAND calculates a
new route.
Block Area
You can define an area within the map dis-
play that is not to be used by the system in
calculating a route, if possible.
i
The calculated route may include a blocked
area if the destination is within a blocked area or
if the destination can only be reached using
roads that lead through a blocked area.
̈ To set, change or delete: Display
menu system if applicable
(
୴ page 119).
̈ Select “Navi” K “Block Area”.
If no areas were previously set, the
map display appears ready to select
an area.
̈ Slide q m r , o m p or w m x to select an
area.
̈ Press n.
The blocked area appears in red.
̈ Rotate y m z to change the size of the
blocked area.
̈ Press n.
The area is added to the blocked area
list