Mercedes-Benz M-Class 2007 Owners Manual - Manual (Page 290)

289
Controls in detail
Loading
Pulling the partition net tight
Belt hook attached behind the front seats
1 Belt hook
2 Cargo tie-down ring
3 Tightening belt
̈ Hook belt hook 1 into cargo tie-down
ring 2 in direction of arrow.
̈ Pull tightening belt 3 by the loose end
in direction of arrow until the partition
net is pulled tight.
̈ After driving a short distance, make
sure the partition net is still tight and, if
necessary, pull it tight again.
Loosening the partition net
Belt hook attached behind the front seats
1 Buckle
2 Belt hook
3 Cargo tie-down ring
̈ Loosen the tightening belt by pulling
buckle
1 upward in direction of arrow.
̈ Remove belt hook 2 from cargo
tie-down ring 3.
Removing and storing the partition net
̈ Take partition net bar 2 out of
holder 1, see “Installing the partition
net” ( ୴ page 288).
̈ Press the red button on the upper and
lower partition net bar.
̈ Fold the partition net.
̈ Roll up the partition net.
̈ Close the zipper on the partition net
package.