Old Town Kevlar Skid Plate Kit - Manual (Page 3)

Skid Plate Kit
Installation
Instructions
125 Gilman Falls Road
Building B
Old Town, ME 04468 USA
800-8-KAYAKS
www.oldtowncanoe.com
Please read kit instructions carefully prior to installation.
Many of our kit installations can be viewed at
www.youtube.com/oldtowncanoeandkayak
Rev.A
Issue Date: 12/08/2010
Doc. # K-01.1331.0640
Page 3 of 5
Fig.#4 Pour Hardener into Resin
Fig.#5 – Apply resin to hull
Fig.#6 Lay Felt
Fig.#7 Apply Resin to Felt

Mix resin by pouring all of one can B (hardener) into one can A
(resin) and stirring thoroughly with the stirring stick for
approximately 1 minute– See Fig.#4 . Make sure to scrape the
inner sides of the can to achieve a uniform mix.

With the paintbrush, apply a light layer of mixed resin to the area
that has been sanded – See Fig.#5. The sanded area should be
completely covered with the resin.

Lay the dry felt carefully in place. Pat it firmly with your (gloved)
hand or the paintbrush to bring the excess resin up through the skid
plate – See Fig.#6.

Using the brush, apply as much of the remaining resin as needed to
completely wet through the felt – See Fig.#7.

Remove any air trapped under the felt by gently working it over to
the edge