Oldcastle BuildingEnvelope Thermal Clad Door and Frame - Manual (Page 26)

FINAL ADJUSTMENTS TO DOOR
26 MAY 2012
D O O R & F R A M E I N S T A L L A T I O N M A N U A L
Web Address: www.oldcastlebe.com
Phone: 1-866-OLDCASTLE (653-2278)
Figure 2
Figure 3
Figure 4
On offset pivot doors:
1) Open doors and turn bottom pivot support screws down until they contact the slab. Do not
over-drive the screws because of additional stress being placed on pivot. See FIGURE 2
2) If top of door on hinge side is not 1/8" below the frame, remove adjustment screw cover (See
FIGURE 3), insert allen wrench into top side of pivot and adjust as necessary. Screw will be
turned clockwise to raise door and counterclockwise to lower. See FIGURE 4
3) If door opening is out more than adjustable pivot can adjust. Loosen set screw on bottom frame
pivot, raise secondary adjustment screw then tighten set screw back in place. See FIGURE 2.
Repeat step 2 as required.