Origin Live Sovereign MKI - Manual (Page 3)

3
S E T T I N G U P T H E P L I N T H
Place the motor pod in position and then lower the
plinth over it as shown in photo.
L E V E L T H E T U R N T A B L E P L I N T H
The deck has screw feet in the underside of each large chrome pod. These can be used
to adjust the height of the pods. They rotate easily and can be adjusted by lifting a pod
by hand, to approx 25mm height and rotating the foot with your fingers. If the screw
is tightly screwed in, then it can be loosened using the allen key provided. You need not
lock these feet once you have adjusted them.
Ideally use a round spirit bubble level to level the plinth.
There ar 2 methods to level the deck depending on whether you have a support table
that can be levelled.
1) Screw in each threaded foot such that it protrudes from the base of the pod by approx
1mm. Then level the table that the deck sits on till the plinth is level.
2) Alternatively - level the deck using the threaded feet.
����������
������
������
������������
�����������
You will find the spacer support post fitted as shown
in the diagram minus the spacer. Fit the 30mm spacer
tube over the support post as shown opposite.
NOTE: The 3 bolts underneath the plinth holding it
to the bottom silver plate should only be finger tight
– do not tighten these as the sound will degrade if
you do.