Pridiom Classic Series PMS361CL Remote Control Manual - Manual (Page 3)

TEMP Button : Push this button to decrease the indoor
o O temperature setting in 1 F increments to 62 F.
FP Button: During the heating operation(only when the
setting mode is HEAT), press this button and the unit will
operate at high fan speed with the temperature automatically
O O set to 8 C/46 F. The display window of indoor unit will display
FP . Press the buttons of ON/OFF, MODE, FAN SPEED,
TEMP UP/DOWN, TIMER ON/OFF, SLEEP or FP while
operating will cancel the FP function.
RESET Button: When you press the recessed RESET button,
all current settings are cancelled and the control will return to
the initial settings.
SLEEP Button: Press this button to go into the Energy-Saving
operation mode. Press it again to cancel. This function is only
can be used on COOL, HEAT and AUTO mode and maintain the
most comfortable temperature for you.
2
1
6
ON/OFF Button: Push this button to start operation, push
the button again to stop operation. 9
TEMP Button : Push this button to increase the indoor
o O temperature setting in 1 F increments to 86 F.
2
AIR DIRECTION Button: Used to change the louver
movement and set the desired up/down air flow direction.
O The louver changes 6 in angle for each press.
MODE Selection Button: Each time the button is pressed,
the operation mode is shifted in the direction of the arrow:
AUTO COOL DRY HEAT FAN
3
FAN SPEED Button: Used to select the Fan Speed in four steps-
AUTO LOW
MED or HIGH. Each time the button is pressed,
the fan speed mode is shifted.
8
TIMER ON Button: Press this button to initiate the auto-on time
sequence. Each press will increase the auto-timed setting in 30
minutes increments. When the setting time displays 10h, each
press will increase the auto-timed setting 60 minutes increments.
To cancel the auto-timed program, simply adjust the auto-on time
to 0.0. 10
11
4
5
NOTE: While the unit is running under SLEEP operation mode, it would
be canceled if you press the MODE,FAN SPEED or ON/OFF button.
NOTE: FP button is available for Model RG51M1/EU1
only.
1
Model
Transmission Distance
Rated Voltage
RG51M5/(C)EU, RG51M1/EU1
8m
3.0V(Dry batteries Lr03 2)
Remote Controller Specification
Performance Features
Features of Remote controller buttons
1. Operating Mode: AUTO COOL DRY
HEAT(Cooling only model without) and FAN .
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range:
4. Full function of LCD (Liquid Crystal Display)
Fig. 1
TEMP
AUTO
COOL
DRY
HEAT FAN
HIGH
MED
LOW
MODE FAN SPEED
TIMER ON SLEEP
ON/OFF
TIMER OFF
AIR
DIRECTION
RESET LOCK
1
2
4
5
6
7
3 8
9
10
11
12
13
14
15
Environment
SET TEMPERATURE( F)
SWING
LED
DISPLAY
TURBO
SWING Button: Push this switch button to activate auto
swing feature of the horizontal louver. Push it again to stop.
7
O O 62 F~ 86 F
O
O O 23 F~140 F
FP
NOTE Please do not select HEAT mode if the machine you
purchased is cooling only type. Heat mode is not supported by
the cooling only appliance.
NOTE: Press and hold and buttons together for 3 seconds will
O O alternate the temperature display between the C & F scale.