4 gate and latch adjustment procedure – Rice Lake Mobile Group Animal Scale - MAS-M - Operators Manual User Manual
Page 18
Advertising
14 MAS-M Operator’s Manual
2.4
Gate and Latch Adjustment Procedure
The gates shall be assembled following the listed criteria:
• Hook Bolts - Assemble with lock washer on inside of gate and jam
nut on the outside.
• Hinge Side Gap - Approximately 3” between the gate and the
corner post.
• Gate Latch Pin - Install rubber tubing on the latch pin (Mobile units
only).
Adjust gates as follows:
1. Adjust the hook bolts to align the top of the gate on the latch side with the top of
the cage wall.
2. Adjust the hook bolts so the latch side gap is about 1 1/2”.
3. Install and adjust the latch so the gate latch pin does not rub on the top or bottom
of the latch. Adjust the hook bolts only if necessary.
Note
Advertising
This manual is related to the following products: