Standard calibration (continued), Step operator action displayed message comment, Observe the display – Rice Lake Datamax M-Class User Manual
Page 79: Or, for reflective media, Or, for continuous media, The calibration was successful
M-Class
71
Standard Calibration (continued)
Step
Operator Action
Displayed Message
Comment
9
Observe the display.
!
HBQ!NPEF!
DBMJCSBUJPO!DPNQMFUF!
!
!
Or, for reflective media:
!
SFGMFDUJWF!NPEF!!
DBMJCSBUJPO!DPNQMFUF!
!
!
Or, for continuous media:
!!
DPOUJOVPVT!NPEF!!
DBMJCSBUJPO!DPNQMFUF!
The calibration was successful.
See note below if another message was displayed.
10
Exit upon successful calibration:
Back out of the menu tree by
repeatedly pressing the
Key.
If using gap or reflective media,
press and hold the
Key.
The printer will begin advancing
media; allow at least one label
gap (or mark) to advance under
the sensor.
!
UIV!22;42B!36NBS3115!!
SFBEZ!
!
The printer is now ready to begin printing.
If this calibration was unsuccessful, go to Section
5.4.3.
Note: A ‘Warning Low Backing’ message indicates that the calibration was successful with notched media or media on a
transparent liner; see Section 7.1 for details on this and other possible messages.