Series – Rice Lake Ranger Count 3000 Series, Ohaus User Manual
Page 24
EN-22
Ranger™ Count 3000
Series
4.7 COM1 Menu
Enter this menu to define communication parameters. Default settings are in bold.
Note:
The COM2 menu is only displayed if a second interface is installed.
Reset
[reset]
Reset the COM menu to factory defaults.
NO = no reset
YES = reset
Baud Rate
[BAUD]
Set the baud rate.
300
= 300 bps
600
= 600 bps
1200
= 1200 bps
2400
= 2400 bps
4800
= 4800 bps
9600
= 9600 bps
19200
= 19200 bps
Parity
[paritY]
Set the data bits and parity.
7 EVEN = 7 data bits, even parity
7 ODD
= 7 data bits, odd parity
7 NONE = 7 data bits, no parity
8 NONE = 8 data bits, no parity
Stop bit
[stOP]
Set the number of stop bits.
1
= 1 stop bits
2
= 2 stop bits
Handshake
[H.shake]
Set the flow control method. Hardware handshaking is only available for COM1 menu.
NONE
= no handshaking
ON-OFF = XON/XOFF software handshaking
Reset:
no
, yes
Baud Rate:
300…9600…
19200
Parity:
7 even, 7 odd, 7 none, 8 none
Stop bit:
1
, 2
Handshake:
none
, On-Off
Alternate command: Print (A…P…Z), Tare (A…T…Z), Zero (A…Z)
End COM:
Exit menu