Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 9)

6
Setting Units
To obtain the desired units press;
until the desired MODE LED is on.
Eg. – Kilograms
Changing ID Number
The ID number for your system is factory programmed. If you
wish to change this ID number follow the instructions below:
a) Insert a programming jumper onto the On-Board Control
Board. Cycle power, then type the following sequence on
the M2000
b) The indicator will prompt you to enter an ID.
c) Enter the id using the keypad on the indicator followed by
the [PRINT/SELECT] key.
d) When done programming the ID remove the
programming jumper and cycle power.
Note: If a mistake is made entering the ID, pressing [CLEAR]
will exit id programming mode. Press [START] again to enter
the correct number.
IMPORTANT: Programming the id sets the system to
return to the default ‘single weigh mode’ operation. Refer to
the next section for details on setting the mode.