Sage Nutri Juicer Plus BJE520UK User Manual

Page 23

Advertising
background image

22

PAge heAder.....

troUBlESHootIng

PoSSIBlE ProBlEm

EaSy SolUtIon

machine will not work
when switched on

The safety locking arm may not be correctly engaged

in the vertical operating position with the locking arm

located into the two grooves on either side of the

juicer cover.

motor appears to stall
when juicing

Wet pulp can build up under the juicer cover if the

juicing action is too vigorous. Try slower juicing action

by pushing the food pusher down more slowly. Follow

Disassembling and Cleaning instructions and clean the

filter bowl surround, the juice disc and the juicer cover.

The juicer will automatically stop operating if the motor

is stalled for more than 10 seconds. Either too much food

is being processed at one time or the pieces are not small

enough. Try trimming the food or cutting into smaller

pieces of even size and processing a smaller amount per

batch. To continue juicing, reset the juicer by pressing the

ON/OFF switch on the control panel to OFF then turn the

appliance back on by pressing ON/OFF switch to ON.

Hard fruits and vegetables will put excess strain onto the

motor if a low speed is selected. Please refer to the juicing

guide to determine the correct speed for the fruits and

vegetables selected for juicing.

Excess pulp building
up the stainless steel
filter disc

Stop the juicing process and follow Disassembling

Instructions. Remove the juicer cover, scrape off pulp,

reassemble and begin juicing again. Try alternating (soft

and hard) vegetable and fruit varieties.

Pulp too wet and
reduced extracted
juice

Try a slower juicing action.

Remove juice disc and thoroughly clean mesh walls with a

cleaning brush. Rinse the juice disc under hot water. If the

fine mesh holes are blocked, soak the basket in a solution

of hot water with 10% lemon juice to unblock the holes or

wash in the dishwasher. This will remove excess fibre build

up (from fruit or vegetables) which could be inhibiting the

juice flow.

Juice leaks between

the rim of the
juicer cover

Try a slower juicing speed and push the food pusher down

the feed chute more slowly.

Advertising