Sage Smart Toast BTA820UK/BTA840UK - Manual (Page 11)

10
oPerATIng yoUr neW APPlIAnCe
5. The QUICK LOOK™ button can
be pressed up until 10 seconds
before the end of the toasting cycle
to view the browning of the bread.
When selected, the QUICK LOOK™
button surround will flash and the
LED toasting progress indicator will
remain steady (indicating that the
selected browning setting has not
been interrupted by the carriage
rising). The toasting recommences
immediately as the carriage lowers
and locks into position, and as
indicated by the QUICK LOOK™
button surround illuminating and
the LED toasting progress
indicator flashing.
6. Approximately 10 seconds before
the end of the selected browning
setting, the QUICK LOOK™ button
will cease illumination. As the
toasting stops and the carriage
rises, the TOAST/CANCEL button
surround will flash and the LED
toasting progress indicator will
cease flashing. The LED
toasting progress indicator will
re-illuminate to the previously
selected browning setting.
7. Once the toasting cycle has
completed and the carriage has risen
and locked into the raised position,
the toast ready alert will sound.
Remove the toast. The TOAST/
CANCEL button surround will
re-illuminate in white for up to 30
seconds, ready for the next
toasting cycle.
noTe
The toaster will revert to stand-by
mode after 30 seconds if a BUTTON
IS NOT pressed or the slide is not
adjusted. All button surrounds and
LED toasting progress indicator will
cease illumination.
noTe
The toaster will re-activate from
stand-by mode and the
TOAST/CANCEL button surround
and LED toasting progress indicator
will illuminate when:
•
Any of these buttons are pressed
(except the TOAST/CANCEL
button which will start the
toasting process).
• The browning control slide
is moved.
• The power at the power outlet is
turned off then on again.
WARNING
Do not leave the toaster unattended
when in use as toast may jam. In the
unlikely event that bread, crumpets or
muffins become jammed in the toasting
slots, all the button buttons and the
LED toasting progress indicator will
flash and the elements will turn off.
Switch the toaster off at the power
outlet, remove the power plug and
allow the toaster to cool completely
before carefully easing the bread
out of slots. Take care not to damage
the elements.