Smart Power Systems LR Series - Manual (Page 26)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 25 of 49
Example of Command & Control Center in normal mode
Figure 13
2.
The PTO driving the SPS hydraulic pump must be engaged for the system to
generate electricity.
3.
The Command & Control Center is equipped with two Smart Touch  switches,
labeled “Mode” and “On/Off” respectively. These switches do not require pressure
to be activated, but instead sense the presence or absence of your fingertip. The
decimal points in the “Amps Line 1” and “Amps Line 2” fields of the Command &
Control Center are used to indicate the status of the Mode and On/Off switches
respectively (reference Figure 14).
Mode Switch Status Light On/Off Switch Status Light
Switch Status Lights
Figure 14
Normally, the status lights will be off. When a switch is pressed, the
corresponding light will be illuminated. When a status light is flashing,
the corresponding switch is calibrating, and the switch should not be
pressed. The system controller will ignore the switch while it is
calibrating.