Snow Joe iON13SS 40-Volt Cordless 13-Inch Brushless Snow Shovel w/ Rechargeable Ecosharp Lithium-Ion Battery - Manual (Page 12)

12
Replacing the Auger
m
WARNING! Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Disassemble the left side cover by removing the five (5)
screws that hold it in place (Fig. 12).
2. Remove the belt from the drive wheel (Fig. 13).
3. Remove the screws and the bushings from the drive wheel
(Fig. 14).
4. Disassemble the right side cover by removing the five (5)
screws that hold it in place (Fig. 15).
5. Secure the auger as you disassemble the auger assembly
nut (Fig. 16).
6. Remove the auger axle set (Fig. 17).
Fig. 12
Fig. 13
Belt
Drive wheel
Fig. 14
Screws and
bushings
Drive wheel
Fig. 15
Fig. 16
Auger assembly nut
Fig. 17
Auger axle set