Snow Joe iON13SS 40-Volt Cordless 13-Inch Brushless Snow Shovel w/ Rechargeable Ecosharp Lithium-Ion Battery - Manual (Page 13)

13
7. Remove the old auger from the housing (Fig. 18).
8. Install the replacement auger by following the above steps
in reverse order (Fig. 19).
Replacing the Belt
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Disassemble the left side cover by removing the five (5)
screws that hold it in place (Fig. 12).
2. Remove the old belt from the body by slowly turning the
auger while lifting the belt (Fig. 20).
3. Replace the worn belt with a new belt (Fig. 21).
4. Place the left side cover back into position and refasten
the five (5) screws.
Replacing the Scraper Blade
m
WARNING! Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your cordless snow shovel.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper blade to the base
of the unit (Fig. 22).
2. Remove the old scraper blade (Fig. 23).
Fig. 18
Auger
Fig. 19
Fig. 20
Belt
Auger
Fig. 21
Belt
Fig. 22
4 screws
Drill
Fig. 23
Scraper blade