Snow Joe SPX2000 Pressure Joe 1740 PSI 1.59 GPM 12.5-Amp Electric Pressure Washer - Manual (Page 6)

Unpacking
Carton Contents
• Electric pressure washer
• Handle
• Trigger gun
• Adjustable spray wand
• Detergent tank with cap and PVC tube
• Two (2) large Phillips head screws (for handle)
• Two (2) small Phillips head screws (for hose holder)
• Hose holder
• Needle clean-out tool (included with manual packet)
• High-pressure hose
• Garden hose adaptor (female coupler) with two O-rings
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe ® + Sun Joe ® customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
m
WARNING! Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Assembly
Tools required: Phillips head screwdriver
1. Following the alignment grooves at the top of the machine
body, slide the handle into position from the front to the
back, so that the solid side of the handle faces the front
of the washer. Secure the handle using a Phillips head
screwdriver and the two (2) large screws (Fig. 1).
2. Fit the cap with the attached PVC tube (black-tipped end)
onto the detergent tank.
3. Using the notch at the top of the detergent tank as a
guide, insert the detergent tank (top end first) under the
ridge on the underside of the handle (Fig. 2). Then snap
the bottom of the tank into the V-shaped groove to secure
it in place (Fig. 3).
Fig. 1
2 large screws
Handle
Alignment
grooves
Fig. 2
Detergent
tank
Fig. 3
Detergent tank
V-shaped
groove
6