Snow Joe SPX2000 Pressure Joe 1740 PSI 1.59 GPM 12.5-Amp Electric Pressure Washer - Manual (Page 7)

4. Run the PVC detergent tube through one of the holes
located at the top of the handle and connect the tube to
the detergent connection (Fig. 4).
5. To assemble the hose holder, slide the holder into position
and secure it to the unit with the remaining two (2) small
screws (Fig. 5).
6. Fit the spray wand into the gun and rotate it until the two
parts are completely locked (Fig. 6).
7. Connect the silver end of the high-pressure hose to the
trigger gun and twist the nut as indicated to secure the
connection (Fig.7).
8. Connect the other end of the high-pressure hose to the
water outlet on the washer and twist the black rotatable
end-piece as indicated to secure the connection (Fig. 8).
m
WARNING! Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
9. Connect the garden hose adaptor (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adaptor
(Fig. 9). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery
capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
Fig. 4
Detergent
connection
Detergent tank
Detergent tube
Fig. 5
2 small screws
Hose holder
Fig. 6
Trigger gun
Fig. 7
High pressure hose
Fig. 8 (FRONT)
High-pressure water outlet
High-pressure hose
7