Snow Joe SPX3001 Pressure Joe 2030 PSI 1.76 GPM 14.5-Amp Electric Pressure Washer with Hose Reel - Manual (Page 12)

12
m
WARNING! Before reusing, completely flush the unit
out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left in the
system before using it again.
Maintenance
m
CAUTION!
Before working on the pressure washer,
disconnect the plug from the power supply socket.
1. To ensure good performance, check and clean the water
inlet filter (Fig. 21). Remove the filter and rinse with warm
water to prevent any foreign matter from clogging the
pump (Fig. 22).
2. Clean the nozzle with the needle clean out tool provided
(Fig. 23). Remove the spray wand from the gun; remove
any dirt from the nozzle hole and rinse.
3. Remove additional debris by back flushing water through
the nozzle and spray wand. To do this, place the end of
your garden hose (with water running) to the tip of the
nozzle, pushing water and debris out of the back opening
of the nozzle and spray wand.
Circuit Diagram
A circuit diagram for the pressure washer is provided below for
your reference (Fig. 24).
Disposal
Recycling the washer
• Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities.
• Contact your local government agency for information
regarding the collection systems available.
• If electrical appliances are disposed of in landfills
or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your
health and well-being.
Fig. 21
(FRONT)
Water inlet filter
Garden hose adaptor
Fig. 22
Inlet filter
15º
Fig. 23
Needle clean out tool
!
Micro-switch
Motor
Capacitor
On/off switch
Power cord
Fig. 24