Snow Joe SPX3001 Pressure Joe 2030 PSI 1.76 GPM 14.5-Amp Electric Pressure Washer with Hose Reel - Manual (Page 6)

6
Unpacking
Carton Contents
• Pressure washer unit
• Handle
• Trigger gun
• Spray wand
• Five (5) Quick-Connect nozzles (0º, 15º, 25º, 40º and Soap)
• Removable detergent tank
• Two (2) small screws
• Spray wand protector
• Trigger gun holder
• Hose holder
• Needle clean out tool
• High-pressure hose
• Garden hose adaptor (female coupler) with two sealing rings
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe ® + Sun Joe ® customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
m
WARNING! Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Assembly
1. Position the washer as CLOSE as possible to the
water supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 1).
3. Slide the trigger gun holder into position and secure it in
place with one screw (Fig. 2).
4. Insert the detergent bottle (bottom end first) into its
storage compartment (Fig 3). Then insert the suction tube
with filter into the bottle and close it with the cap (Fig. 4).
Fig. 1
Fig. 2
Trigger gun holder
Screw
Fig. 3
Detergent
bottle