Clarion OHM641 User Manual
Page 4
WIRING PRECAUTIONS
Read all wiring precautions. If you are not sure of the connections, contact
your authorized Clarion dealer.
1.
Disconnect the negative (-) lead of the battery before making any power
connections.
2. When creating passage holes for the power wires, use grommets to
eliminate any sharp edges created during drilling. This will protect the wire
from being nicked and causing a short circuit.
3. When connecting the ground lead, fasten the ground lead (black) securely
to a clean metal plate on the vehicle.
NOTE: The OHM641 mointor displays video images only. It does not provide audio output. Refer to the
owner’s manual of the connected device for information on audio output.
INSTALLATION
The OHM641 is an overhead, fold-down 6.4” monitor with an Infrared (IR)
eye. It will accept a video signal from any video source with composite video
out. The IR eye will work directly with the TTX001, VDH9600 and DVD9600.
1. Look over the vehicle for a location for the monitor. Each vehicle is
different and locations will vary. Make sure the monitor will not interfere
with the dome light, wiring, water channels or sunroof operation. The
mounting bracket has slots to accomodate various dome light screw
patterns. In some cases, the vehicle dome light may need to be relocated.
2. Once a location has been determined, run the IR extension, video RCA and
power cables above the head liner to the mounting location.
3. Feed the cables through the hole in the mounting bracket and screw the
bracket to dome light mounting rib. Use short screws so as not to damage
the roof.
4