Snow Joe SBJ604E Blower Joe 3-in-1 Electric Blower/Vacuum/Leaf Shredder - Manual (Page 5)

Using the blower/vacuum/
leaf shredder
Note: Before using the blower/vacuum/leaf shredder, familiarise
yourself with all the operating features and safety requirements.
Only use the blower/vacuum/leaf shredder as intended.
Assembling (Fig. 2-4)
1. Ensure that the lower/suction tube and the upper/
suction tube is assembled using the 4 screws provided.
NOTE: Check the tubes are secure before operating the
blower.
2. Connect the collection bag to the machine.
Powering ON and OFF (Fig. 5)
m
WARNING! Before switching on the tool, ensure that it
is not in contact with any object.
1. To power on, push the instant start button.
2. Stop the tool by pushing the Main switch button in "O"
position. Low speed to high speed is from "1" to "6" by
the adjustable switch.
m
WARNING! After switching off the tool the motor
continues to run for a few seconds.
Vacuuming/Shredding (Fig. 6)
Ensure the tubes are assembled correctly before operating the
unit. Make sure the collection bag is connected to the machine.
Turn the transfer lever switch to VACUUM MODE. Turn unit on.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Main Switch Button
Speed Adjustable Switch
VACUUM MODE
Fig. 6
5
2 screws
2 screws