Snow Joe SBJ604E Blower Joe 3-in-1 Electric Blower/Vacuum/Leaf Shredder - Manual (Page 6)

Blowing (Fig. 7)
Ensure the tubes are assembled correctly before operating.
Turn the transfer lever switch to BLOWING MODE. Turn unit on.
Cord restraint (Fig. 8)
• Hook the loop in the extension cord over restraint as
illustrated.
• Pull tight to secure the extension cord.
m
WARNING! Do not vacuum solid objects such as
stones, broken glass, pieces of metal.
• Do not vacuum liquids.
• Do not vacuum large volumes of leaf material at one time
thus avoiding clogging of the vacuuming opening and
blocking of the shredder impeller.
• The shredding intensity depends on the size of the leaf
material and its residual moisture.
m
WARNING! When the tool suddenly stops, immediately
switch it off, disconnect plug from power source, and remove
any jammed material between shredder impeller and housing.
• Regularly empty collection bag (the vacuum capacity
decreases considerably when the collection bag is full).
Holding and guiding the tool
m
WARNING!
While working, always hold the tool at the
light green-colored grip area(s).
• Use supporting wheels for easy guiding the tube along
the ground.
• For optimal distance keep a 5-10 cm to the ground.
Emptying of collection bag (Fig. 9)
m
WARNING!
Switch off the tool and disconnect the plug.
• Wait until the impeller comes to a standstill before
removing the collection bag from the tool.
• Open the zipper of the collection bag and empty it
completely.
• Composte material does not belong with domestic waste.
Maintenance/Service
1. This tool is not intended for professional use.
2. Always keep tool and cord clean.
• Clean the tool after each use with a soft brush or a cloth
(do not use cleaning agents or solvents).
• Remove the collection bag after each use, turn inside out
and clean it thoroughly.
• After removing the collection bag, ensure that possible
dirt residues are removed from the air outlet area.
3. Store the tool indoors in a dry place.
• Do not cover the tool with plastic.
• Plastic may cause moisture and corrosion will result.
4. If the tool should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
power tools.
• Send the tool undismantled together with proof of
purchase to your dealer.
BLOWING MODE
Fig. 7
Fig. 8
Fig. 9
6