Snow Joe TRJ609E-RM Trimmer Joe 3-Amp 9.45-Inch Electric Grass Trimmer - Manual (Page 10)

10
Assembling the spool
NOTE: Users are strongly urged to purchase the pre-wound
spool. A dual-line factory wound spool (Model TRJ609ERS) is
available for easy spool replacement on the TRJ609E electric
grass trimmer. Visit www.snowjoe.com to purchase. When
using the factory wound spool, keep the protective white cover
encasing the line in place, then follow the directions below to
feed the line into the grass trimmer.
1. Insert the spring into the shroud and thread the line into
the hole as shown in Fig. 18.
2. Place the spool cover on the spool and press it firmly
down until the locking devices of the spool cover securely
click into place (Fig. 19).
m
CAUTION! Catapulted pieces of nylon line may
cause injury.
NOTE: The maximum recommended length of line in the spool
is 8 ft (2.5 m) per slot.
m
WARNING! Pay attention to the winding direction.
1. Always replace the spool with a new pre-wound spool.
Visit www.snowjoe.com to purchase the pre-wound
spool (Model TRJ609ERS) for this electric trimmer.
2. Insert the end of the line through the eyelet in the
cutting head.
IMPORTANT: Keep all areas of the cutting head cover and
cutting head clean. Place the cap back by pushing it firmly
onto the cutting head. To ensure that the cutting head cover
is correctly fitted, try to remove it without depressing the two
latches. If it is correctly fitted, it should not move.
Maintenance
m
WARNING! Make sure to unplug your trimmer
before inspecting its parts.
Be sure the tool is unplugged.
• Your grass trimmer requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool.
• Your trimmer line can dry out over time. To keep your line in
top condition, store spare pre-wound spools or bulk line in
a plastic, resealable bag with a tablespoon of water.
• Never use water or chemical cleaners to clean your grass
trimmer. Wipe it clean with a dry cloth.
• Plastic parts may be cleaned by using mild soap and a
damp rag.
• Always store your grass trimmer in a dry place. Do not allow
any liquid to get inside it.
• Keep the motor ventilation slots clean.
• If you see some sparks flashing in the ventilation slots, this
is normal and will not damage your power tool.
• There are no user serviceable parts in the trimmer. If a
fault is suspected, return the trimmer to an authorized
dealer for repair.
IMPORTANT:
To ensure product safety and reliability, repairs, maintenance
and adjustment should be performed by authorized service
centers or other qualified service organizations, always using
identical replacement parts.
Fig. 18
Spring
Fig. 19
Locking
devices
Spool cover
Spool