Snow Joe TRJ609E-RM Trimmer Joe 3-Amp 9.45-Inch Electric Grass Trimmer - Manual (Page 9)

9
Winding the line
NOTE: A dual-line factory wound spool (Model TRJ609ERS) is
available for easy spool replacement on the TRJ609E electric
grass trimmer. Visit www.snowjoe.com to purchase. Should
you wish to wind the line yourself, the instructions are provided
below. Self-winding, however, is
NOT recommended because
if the line is not wound properly it can cause the trimmer’s
bump feed system to malfunction. For this reason, users are
strongly urged to purchase the pre-wound spool.
1. The spool can hold 16.4 ft (5 m) of line. Remove the white
cover. Holding the loose ends of the line together with
one hand, find the center of the line with the other hand
and hook this center loop into the groove on the spool as
shown in Fig. 14.
2. Wind the line following the directional arrows on the
spool housing and hook the two ends into the side
grooves (Fig. 15).
3. Firmly place the white cover on the spool and pull the
two ends approximately 3.5 inch (9 cm) out of the spool
(Fig. 16)
4. Along the groove, slide the line into the hole in the spool
cover (Fig. 17).
5. Prepare to assemble the spool into the trimmer.
Fig. 13
Spool
Fig. 14
Fig. 15
Fig. 16
Fig. 17