Snow Joe TJ600E-RM Tiller Joe 6.5-Amp Electric Garden Tiller/Cultivator - Manual (Page 5)

Assembly
Note: Reference to right or left side of the tiller is determined
from behind the unit in the operating position. The “Operator’s
position” is defined as standing directly behind the tiller.
Follow these steps to assemble:
1. Remove tiller from the carton.
2. Slide the Right-hand Grip (A) and Left-hand Grip (D)
into the Plastic Cross Plate (I). Secure the Plastic Cross
Plate to the Left and Right-hand Grips with the included
screws. (See Fig 2-1, 2-2, 2-3)
Note: Use a phillips-head screwdriver. Aligning the holes
may be difficult. We recommend fastening one hand grip
at a time to the Plastic Cross Plate.
m
CAUTION
m
Inspect wiring, which, if damaged during shipping,
may cause serious bodily injury during equipment use.
If any damage is seen or suspected, do not assemble.
Instead, contact Snow Joe Customer Service
(1-866-SNOW JOE) for assistance.
Handle with care during assembly so that electrical
wiring does not become damaged.
Front View
Figure 2-1
A
D
I
Align the bottom of beam with the white line on the side of
upper handle before tightening 2 screws
Front View
Figure 2-2
Screws
Back View
Figure 2-3
5