Snow Joe TJ600E-RM Tiller Joe 6.5-Amp Electric Garden Tiller/Cultivator - Manual (Page 9)

1. Place the electric tiller on the ground. The rating label
should be facing upward.
2. Unscrew the hex bolt (R) (See Fig. 8) and the self-locking
(S) (See Fig. 8).
3. Remove the tine wheels off the driveshaft (P) (See Fig. 8).
4. Clean the driveshaft (P) with biodegradable oil.
5. Place the new tines onto the driveshaft so that the holes
on the axles line up with the holes on the driveshaft.
IMPORTANT! The tines must be set in the correct turning
direction. Check the arrows on the tines and gearbox point in
the same direction.
6. Insert the hex bolt (R) through the holes and tighten on
the self-locking nut (S).
Storage
• Allow the motor to completely cool down before storing
the Tiller.
• Keep the machine clean, dry and out of the reach of
children.
• Do not cover the machine with a plastic bag. This may
cause moisture build-up.
1. Unscrew the wing-nuts (J) and fold the fork grips down.
2. Check to ensure the Power Cable (E) is not pinched.
3. Hang the machine on the frame tubing.
Service and Support
If your Tiller Joe Electric Tiller/Cultivator requires service or
maintenance, please call 1-866-766-9563 for assistance.
Model and Serial Numbers
When contacting the company or reordering parts, you will
need to provide the model and serial numbers of your product.
These are found on the decal affixed to the housing or handle
of your tiller. Copy these numbers into the space provided
below.
Figure 9
E. Power Cable J. Wing-nuts and bolts
J
E
9
Record the following numbers from the housing or handle of your
new product:
T J 6 0 0 E R M
Model #:
Serial #: