Snow Joe TJ601E-RM 9-Amp Electric Garden Tiller/Cultivator - Manual (Page 6)

M
Q
R
T
6
Unpacking and using for the
first time
Unpacking
Unpacking the product and checking for completeness. See
also: Disposing of packaging – Page 7.
Supplied as standard
• Instructions for use
• Garden tiller
• Grab handles x 2 (1 Control and 1 Grab Handle)
• Cross plate
• 6 wing nuts and bolts
• Belt Clip
• Cable Clip
Note: If a part is missing or damaged, please contact
the vendor.
Assembling the grab handles and
the connector
• (Fig. 1) Insert the control handle (C) and the grab handle
(A) into the holes of the cross plate (F). Make sure that the
control handle is on the side of the cable holder guide of
the cross plate.
• Insert the screw bolts in the holes at the back of the cross
plate, and tighten them. Ensure the handles are tightened
in the cross plate.
• Fix the entire unit with the wing nuts (O) to the frame (H).
• Fix the frame (H) with wing nuts (O) to the tiller frame (J).
Set the tilling depth
How to change the transport status to the tine status
• Firstly, pull the pin (Q) and disassemble the bolt (R), then
pull out the wheel assembly (M) the direction of the arrow.
(Fig. 2)
A
F
H
O
J
C
Figure 1
Figure 2
Transport
status