Cobra Electronics PR3175WX - Manual (Page 10)

Customer Assistance Warranty Introduction
15 Nothing comes close to a Cobra ™
Operation
During Channel Scan (while not receiving a transmission),
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on the channel
or channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission. This will return the radio
to Standby mode.
b. Press the Mode button to proceed to set privacy code scan on
the channel that was either displayed before you entered mode
functions or on which, during channel scanning, you last
received a transmission (see below for further details).
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission.
Privacy Code Scan
•
Your microTALK ® radio can automatically scan the Privacy Codes
(00 through 38) within one (1) channel.
To Scan Privacy Codes:
1. While in Standby mode, press the
Channel Up or Channel Down button to
choose the channel on which you wish
to scan privacy codes.
2. Press the Mode button until the Scan icon and
the privacy code numbers flash on the display.
3. Press the Channel Up or Channel Down
button to begin scanning privacy codes
within the channel you selected.
The Scan icon will continue to be displayed
when privacy code scan is On. Your radio will
continue to scan privacy codes and stop as an
incoming transmission is detected. Your radio
will remain on that channel/privacy code for
ten (10) seconds.
14 English
Mode Functions
Channel Scan
•
Your microTALK ® radio can automatically scan channels.
To Scan Channels:
1. Press the Mode button until the Scan icon
and the channel numbers flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning channels.
The radio ignores specific privacy
codes while scanning channels.
The Scan icon will continue to be displayed when
scan is On. Your radio will continue to scan all
channels and stop if an incoming transmission is
detected. Your radio will remain on that channel
for ten (10) seconds.
While setting channel scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel or channel/privacy code displayed
before you entered mode functions.
During Channel Scan (while receiving an incoming transmission),
You Can Choose From The Following:
a. Press and hold the Talk button to communicate on that
channel. Your radio will remain on that channel and return
to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
If you press the Talk button while scanning and not within ten
(10) seconds of receiving a transmission, you will transmit on
the channel on which you last received a transmission. This will
return the radio to Standby mode.
If you do not press any button within ten (10) seconds, your radio
will automatically resume scanning channels.
Operation
Channel Button
Mode Button
Select Channel
Scan Privacy Codes
Scanning Channels
Mode Button
Channel Button
3175-PDF VERSION.qxd 11/20/03 10:45 AM Page 14