Cobra Electronics PR3175WX - Manual (Page 12)

Customer Assistance Warranty Introduction
19 Nothing comes close to a Cobra ™
Operation
18 English
Mode Functions
If you press the Talk button while scanning and not within ten (10)
seconds of receiving a transmission, you will transmit on the
memory location on which, during scanning, you last received
a transmission. This will return the radio to Standby mode.
If you do not press any button within ten (10) seconds, your radio
will automatically resume scanning memory locations.
During Memory Location Scan (while not receiving a
transmission), You Can Choose From The Following:
a. Press and hold the Talk button to communicate on the
channel/privacy code that was displayed before you entered
mode functions or memory location on which, during
scanning, you last received a transmission. This will
return the radio to Standby mode.
b. Press the Mode button to proceed to other functions.
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the memory location on which, during
scanning, you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 13
to de-program a memory location.)
VibrAlert ® And Call Tones
•
Your microTALK ® radio can alert you to incoming signals by
sounding an audible call tone, by vibrating silently, or both.
To Change Call Settings:
1. Press the Mode button until
the Call Setting icon flashes
on the display. The current
setting (vibrate + ring,
vibrate only, or ring only)
is displayed.
2. Press the Channel Up or
Channel Down button to
change the call setting.
3. Choose one (1) of
the following:
a. Press the Mode button
to enter the new setting
and proceed to other functions.
b. Press the Lock button to enter the new
setting and return to Standby mode.
Ten (10) Call Tone Settings
•
You can choose between ten (10) different call tone settings to
transmit a unique call alert.
To Change A Call Tone Setting:
1. Press the Mode button until the letter “C”
and the current call tone number (01 through
10) is displayed.
2. Press the Channel Up or Channel Down
button to hear the other call tone settings.
3. Choose one (1) of the following:
a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press the Lock button to enter the new
setting and return to Standby mode.
Operation
Mode Button
Call Tone Setting
Channel Button
Mode Button VibrAlert ® + Ring
VibrAlert ® Only
Ring Only
Channel Button
3175-PDF VERSION.qxd 11/20/03 10:45 AM Page 18