Tjernlund VH1-6,8,10 Vent Hoods 8504054 Rev B 09/00 - Manual (Page 2)

INSTALLATION
The VH1-8 and VH1-10 do not have a secondary heat shield. A thimble will have to be added to maintain clearances to
combustibles if penetrating a combustible wall with these models.
1. Use inside wall cover plate as a template to mark a hole on appropriate place on wall. Cut hole 1/2” larger to facilitate
installation.
2. Slide hood through opening from outside. Fasten the vent hood with provided anchors and screws.
3. Install cover plate and fasten to inside wall with provided anchors and screws.
4. Seal all vent pipe connections between the Power Venter and vent hood with high-temperature silicone sealant or metal
tape to prevent flue gas leakage.
MAINTENANCE
The vent system must be inspected regularly. Points of inspection are as follows.
1. Screened opening of the vent hood should be free from foreign material and cleaned as necessary.
2. Structural integrity of the vent hood should be maintained so as not to reduce vent discharge opening.
3. Check all vent system connections for leakage and re-seal where needed. If any vent pipe shows signs of deterioration,
replace immediately and check new connections for possible leaks. Re-seal with high-temperature silicone sealant or
metal tape to prevent flue gas leakage.
TJERNLUND LIMITED ONE YEAR WARRANTY
Tjernlund Products, Inc. warrants to the original purchaser of this product that the product will be free from defects due to faulty material or workmanship for a period of (1) year from the date of origi-
nal purchase or delivery to the original purchaser, whichever is earlier. Remedies under this warranty are limited to repairing or replacing, at our option, any product which shall, within the above stat-
ed warranty period, be returned to Tjernlund Products, Inc. at the address listed below, postage prepaid. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE
FACE HEREOF, AND TJERNLUND PRODUCTS, INC. EXPRESSLY DISCLAIMS LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OF THIS PRODUCT.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES AND NO AGENT IS AUTHORIZED TO ASSUME FOR US ANY LIABILITY ADDITIONAL TO THOSE SET FORTH IN THIS
LIMITED WARRANTY. IMPLIED WARRANTIES ARE LIMITED TO THE STATED DURATION OF THIS LIMITED WARRANTY. Some states do not allow limitation on how long an implied warranty
lasts, so that limitation may may not apply to you. In addition, some states do not allow the exclusion or limitation of incidental or consequential damages, so that above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. Send all inquiries regarding warranty work to Tjernlund Products, Inc.
1601 9th Street, White Bear Lake, MN 55110-6794. Phone (651) 426-2993 • (800) 255-4208 • Fax (651) 426-9547 or email us at [email protected].
P/N 8504054 ©2000, Tjernlund Products, Inc. REV. B 9/00