United Security 900MHz Wireless Pressure Mat - Manual (Page 6)

Setting up your WPM for use with an Inovonics FA
Series Receiver, or coding the WPM for use with a
USP 900MHz Receiver if the WPM has not been
programmed (coded) by USP.
1. Complete steps 2 and 3 in “Setting Up”
procedures on Page 1.
2. With the Transmitter outside the Mat, remove the
four small Phillips screws that hold the two
housing sections together and separate the
housings.
3. When prompted by the programming device to
plug in the transmitter, connect the programming
cable to the 3-pin header located next to the
transmitter battery.
4. Press the internal reset button located next to the
battery.
5. Disconnect the programming cable.
6. Fit the housing sections together making sure the
gasket is in place and install the four small Phillips
screws.
7. Locate the two-part Red Connector and plug
securely together.
8. Place the Transmitter (and wiring) inside the Mat,
situating the Transmitter as shown in Fig. A,
Page 5.
9. Close the Transmitter pocket by pressing the
Velcro seam together.
2 5
Fig. A