Universal Remote Control (URS) MX-1200 - Manual (Page 6)

MX-1200 C
OLOR
T
OUCH
S
CREEN
Connecting the Battery Pack
Unlock the rear cover by pressing down on the spring lock at the
top of the cover. Remove the cover. For shipment from the factory,
the battery is left out of the MX-1200. Place the battery into the
battery compartment, making sure you align the contacts on the
battery to the contacts on the MX-1200. The battery will snap into
place when aligned properly. Replace the cover and snap it into
place.
Using the Charging Base
Plug the 5V adapter into a power outlet and
into the back of the charging base.
Gently place the MX-1200 into the cradle of
the charging base. It automatically aligns itself
to the contacts on the charging base.
The Status light should immediately light. Red
indicates that it is charging. Blue shows that it
is fully charged. There is no harm in leaving
the MX-1200 on its charging base whenever
it is not in use.
Page 3
Red indicates charging, Blue that
the remote is fully charged.