Vintage Cellars VintageView 4' Half Island Display Rack Assembly Instructions - Manual

VintageView Half Select 4
(IDR4-H-PRS) Assembly
Instructions
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501
Please feel free to contact us regarding the assembly of this product.
†
IDR Extension packages contain only 1 IDRx-UPRIGHT and 2 footer pads.
Hardware shown
actual size
4 X †
Footer Pad
24 X
IDR-PR Assembly
Screws
16 X
IDR-PR Assembly Bolt
32 X
IDR-PR Assembly
Washer
Required tools: IDR-AK - included with IDR and contains an
8mm Nut Driver and Alignment Tool
Electric Screw Driver with #2 Phillips Bit
2 X 14mm (or adjustable) Wrench
8 X
IDR-PR
2 X †
8 X
IDR-H-PRR
2. Assemble presentation racks k c a r n o it a t n e s e r p n o it i s o P –
(IDR-PR) piece and presentation rack rail (IDR-H-PRR) back to
back as shown. Using the nut driver (included) and a Phillips head
screwdriver, fasten the presentation rack and rail together with
IDR-PR assembly screws. Fully tighten and repeat for all remaining
sets.
2 X †
Rear Footer Pad
Washer
2 X †
Rear Footer
Pad Nut
1. Assemble frame - Thread footer pads into the front-bottom of
the uprights. For the rear footer pads, place a rear footer pad washer
over the shaft of a footer pad. Insert and hold a rear footer pad
nut inside the tube, aligned with the pre-drilled hole, and thread
the footer pad into the nut. Tighten all of the footer
pads with a 14mm wrench. Lay down one upright
and attach all three crossrails using the provided
crossrail assembly screws in the predrilled mounting
holes. Do not fully tighten at this point to allow
for adjustments during assembly.
the second upright to crossrails.