Casio EXILIM EX-H20G - Manual (Page 107)

107
Using the Hybrid-GPS
3.
Taking care not to drop the camera, slowly swing it around in a figure
eight for about 10 seconds.
Use the wrist of the hand that is holding the camera to move in a way that forms a
figure eight. This will correct for the magnetism and adjust direction sensor
accuracy.
The message “Completed normally.” will appear to let you know that accuracy
adjustment is complete, and the map screen will return to the display.
• If the message “Correction failed. Try again.” appears, perform the above
procedure again.
• Performing this adjustment near a train, an automobile, a magnet, or a
concentration of metal can result in incorrect adjustment.
• Direction sensor adjustment is not supported while “Off” is selected for the
“GPS” setting (page 92).
You can use this procedure to convert position information (latitude and longitude)
accompanying an image recorded on another manufacturer’s camera so it can be
played back in the MAP mode of this camera.
1.
Use the Photo Transport that comes with the camera to copy the other
manufacturer’s image with position information from your computer to
a memory card (page 129).
2.
Turn off the camera and load the memory card that contains the data.
3.
Turn on the camera and then press [ý] (MAP).
4.
Press [MENU]. On the “MAP” tab, select “Update Info” and then press
[6].
5.
Use [8] and [2] to select “Update” and then press [SET].
The message “Busy... Please wait...” will appear as the data is being transferred.
After that, the image with position data will be displayable in the MAP mode.
IMPORTANT!
• The position information of certain types of images may not be able to be updated.
Converting Location Information of Images from Another
Source for Playback on This Camera (Update Info)
B