Canon VB-C60B User Manual

Page 90

Advertising
background image

2-32

4. Check the motion detection status of the camera

Check “Display motion detection status of the camera” to confirm the status of the motion
detection with the settings you have configured. The motion detection status is displayed
using one of the following icons.

You cannot save the settings with “Display motion detection status of the camera” checked.
Clear the check to save the settings.

“Detection disabled”

“Detected”

“Not detected”

Note

● Because the video distribution frame rate may be lowered when the data is sent

via a proxy server, connection without using a proxy server is recommended while

setting the motion detection.

● It is recommended that the detection sensitivity is set under condition close to

actual operation condition as much as possible.

Tip

● Even if changes occur in the video image in the detection area during viewing the

viewer, the VB-C60 does not recognize it as “motion” if the sensitivity is set to a low

level. In addition, even when you increase the sensitivity, unless the size of the area

where a motion is detected within the area frame and the duration of the motion

meet the set values, the status of the VB-C60 does not become “Detected”.

● You can also select the detection area to set by clicking it in the viewer. The selected

detection area frame is displayed in a blue solid line frame.

● When Selected area is set to “Not specified”, the detection statuses of all of the detection

areas you have created can be displayed simultaneously. Clicking on a location for

which no area frame is set in the viewer can display them in the same manner.

Motion Detection Setting Tool

7Duration

When changes in the video image in the detection area meet the conditions set in 3
“Sensitivity” and 6 “Size” and continue for the value set in “Duration”, the status of the
VB-C60 becomes “Detected”.

“Duration” is normally fixed at “0.2”. However, the “Details” check box is checked, you can
set the value by directly entering the value or dragging the slide bar in the range of 0-5
seconds.

8Details

When the checkbox is checked, you can set the values for “Sensitivity”, “Size” and “Duration”
by entering numeric values. When unchecked, “Duration (sec.)” is fixed at “0.2”.

Advertising