Installation instructions, Electrical connection, Operating your wine cooler – Vintage Cellars 272 03 21 Silent 21 Bottle Dual Zone Touchscreen Wine Refrigerator User Manual

Page 5

Advertising
background image

Installation Instructions

Before using your wine cooler
 Remove the exterior and interior packing
 Check to be sure the following parts are included:

 7 Slide out shelves.
 1 Instruction manual.

 Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the

possibility of a malfunction in the cooling system from handling during transportation.

 Clean the interior surface with lukewarm water using a soft cloth.
 Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.

To level your appliance, adjust the front legs at the bottom of the appliance.

 Not designed for placement in adage or basement.
 The appliance is for indoor use only.

Electrical Connection

This unit should be properly grounded for your safety. The power cord of this unit is equipped with a 3-pin plug which mates

with 3-pin wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the ground

wine from the power cord supplied.

Use of extension cords is not recommended.

This unit requires a standard 115V-60HZ electrical outlet with 3-pin plug.

The cord should be secured behind the wine cooler and not let exposed or dangling to prevent accidental injury.

Operating Your Wine cooler

It is recommended that you install the wine cooler in a place where the ambient temperature is between 51°F - 80°F. If the

ambient temperature is above or below recommended temperatures, the performance of the unit may be affected. For example,

placing in extreme cold or hot conditions may cause interior temperature to fluctuate. The range of 44 - 64°F may not be

reached.

The temperature may fluctuate depending on whether or not the interior light is on or off or whether the bottles are located on

the upper, middle or lower section.

How to set the temperature:

There are three touch-buttons on the control panel:

• When you are facing the wine cooler, the keys on your left are to control the upper zone, and keys on your right are to

control the lower zone.

• “ ” and “ ” increases or decreases the set temperature by 1°F (temp range is 44-64°for upper zone and 51-64°F

for lower zone).

• “ ” button turns on or off the interior light.

Warning

Improper use of the grounded plug can result in the risk of electrical shock. If the power

cord is damaged, have it replaced by an authorized service center.

Advertising