Vintage Cellars 272 03 21 Silent 21 Bottle Dual Zone Touchscreen Wine Refrigerator - Manual (Page 6)

Note:
• When the ambient temperature is 70°F or less, unit is capable of maintaining a set temperature range between 44-64°
F.
• When the ambient temperature around 77°F, or less, unit can maintain a temperature range between 51-64°F.
Care And Maintenance
Cleaning your wine cooler
 Unplug the wine cooler and remove the bottles.
 Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to
a quart of water.
 The outside of wine cooler should be cleaned with mild detergent and warm water.
 Draw out the water box at the bottom, and wash.
Moving your wine cooler
 Remove all the bottles.
 Securely tape down all loose items inside your wine cooler.
 Turn the leveling legs up to the base to avoid damage.
 Tape the door.
 Be sure the wine cooler stays in the upright position during transportation.
Trouble Shooting
You can solve many common wine cooler problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling the service center.
PROBLEM POSSIBLE CAUSE
Wine cooler does not operate Not plugged or using different voltage. The circuit
breaker may be tripped or a fuse may be blown.
Wine cooler is not cold enough Check the temperature control setting.
External environment may require a higher setting.
The door is has been opened too often.
The door is not closed completely.
The door seal does not seal properly.
The wine cooler does not have the correct clearance.
The light does not work Check to see if the bulb has burned out.
Vibrations Check to assure that the wine cooler is level.
The wine cooler seems to make too much
noise
The wine cooler is not level.
Check the fan.
The door will not close properly The wine cooler is not level.
The doors were reversed and not properly installed.
The seal is weak.
The shelves are out of position.
LED display not working Main control board does not work.
PCB Problem.
There is a problem with the plug.
LED display error Weak quality of display.
Temperature is off.
Buttons are not functional Temperature controller panel is damaged