Vinten Radamec Fusion FH-145 - Manual (Page 4)

2
Installation Guide
Safety and Warnings
Follow all warnings and instructions marked on the
product and in this manual. Safety warnings are
included in this manual. These safety instructions must
be followed to avoid possible personal injury and
damage to the product.
WARNING! Do not install this product onto a bracket,
support or other equipment that is not designed to
support the weight of the product and its payload. All
supports must comply with local government
regulations.
WARNING! The fitting of non-approved parts and
accessories, or the carrying out of non-approved
alterations or servicing can be dangerous and could
affect the safety of the product. It may also invalidate
the terms and conditions of the product warranty.
WARNING! This product must be connected to a
power supply of the same voltage (V) and current (A)
as indicated on the product and described in the
Technical Specifications section of this manual. To
reduce the risk of electric shock, do not remove the
covers. No user-servicable parts inside. Refer all
servicing to qualified service personnel.
WARNING! This product is Class 1 equipment. For
safe operation this equipment must be connected to
a power supply that has a protective earth connection
(US: ground).
CAUTION! FHR-145 only – This product is designed for
robotic use only and is operated remotely. Do not
attempt to operate this product manually.
CAUTION! Slots and openings are intended for
ventilation purposes to ensure reliable operation of
the product and protect it from overheating. Do not
block or cover any slots and openings.
CAUTION! Do not use solvent or oil-based cleaners,
abrasives or wire brushes to remove accumulations
of dirt as these damage the protective surfaces. To
clean mechanical surfaces, use only detergent-based
cleaners.
CAUTION! Do not use oil or grease on any exposed
part of the product. This is unnecessary and traps dirt
which acts as an abrasive.
WARNING! Risk of personal injury. All personnel must
be fully trained and adhere to correct manual handling
techniques. It is the responsibility of the individual and
the local organisation to enforce safe working practices
at all times.
WARNING! Risk of personal injury or injury to others. All
personnel must be fully trained and adhere to local
health and safety laws and guidelines. It is the
responsibility of the local organisation to enforce safe
working practices at all times.
For your personal safety, read these instructions. Do not
operate the product, if you do not understand how to use it
safely. Save these instructions for future reference. Electrical Connections
Basic Electrical Insulation (Class 1 equipment)
Ventilation and Overheating
Cleaning and Maintenance
WARNING! When wiring directly to a studio power
supply, the product must be connected to a switched
3A fused outlet.
FH/FHR-145 Pan and Tilt Head