Welch Allyn 4900 Series Mobile Stand - User Manual User Manual
Cleaning instructions
Accessory Cable Management
Mobile Stand
4800/4900 Series Cleaning Instructions
4800-60, 4900-60
Material number 722730
© 2014 Welch Allyn, Inc.
Clean the Welch Allyn Accessory Cable Management
Mobile Stand on a routine basis according to your facility’s
protocols and standards, or local regulations. Disinfect the
stand according to your facility’s protocols and standards,
or local regulations.
The following products have been identified as being
compatible with the Welch Allyn Accessory Cable
Management Mobile Stand:
•
Hydrogen peroxide cleaner disinfectant Wipes
(Clorox Healthcare
®
)
•
Dispatch Hospital Cleaner Disinfectant Towels with
Bleach (Clorox Healthcare
®
)
•
70% Isopropyl alcohol
•
10% chlorine bleach
WARNING: Disconnect the Connex
®
Vital Signs
Monitor from the power source before cleaning or
disinfecting the stand.
Cleaning Instructions
1.
Wipe the stand using one of the cleaning agents listed
above, following the cleaning agent manufacturer’s
guidelines.
2.
Allow the stand surface to dry for a minimum of
10 minutes before using the stand.
Accessory Cable Management
Mobile Stand
4800/4900 Series Cleaning Instructions
4800-60, 4900-60
Material number 722730
© 2014 Welch Allyn, Inc.
Clean the Welch Allyn Accessory Cable Management
Mobile Stand on a routine basis according to your facility’s
protocols and standards, or local regulations. Disinfect the
stand according to your facility’s protocols and standards,
or local regulations.
The following products have been identified as being
compatible with the Welch Allyn Accessory Cable
Management Mobile Stand:
•
Hydrogen peroxide cleaner disinfectant Wipes
(Clorox Healthcare
®
)
•
Dispatch Hospital Cleaner Disinfectant Towels with
Bleach (Clorox Healthcare
®
)
•
70% Isopropyl alcohol
•
10% chlorine bleach
WARNING: Disconnect the Connex
®
Vital Signs
Monitor from the power source before cleaning or
disinfecting the stand.
Cleaning Instructions
1.
Wipe the stand using one of the cleaning agents listed
above, following the cleaning agent manufacturer’s
guidelines.
2.
Allow the stand surface to dry for a minimum of
10 minutes before using the stand.