Welch Allyn 49506 Light Source - User Manual - Manual (Page 10)

8
FUSE REPLACEMENT
1. Turn the unit off and remove the power cord from both the wall outlet and
the Welch Allyn Light Source.
2. Use a small screwdriver to remove the fuse holder above the power cord
connector by releasing the spring-loaded snap connections.
3. Pull out the fuse holder.
4. Remove and replace with new fuses of the same type. There is no
required orientation of the fuses. Be sure to replace both fuses.
5. Reinsert the fuse holder by pressing it into the power connector until it
snaps into place.
6. If the new fuse blows, immediately contact Welch Allyn Technical Service
at 315-685-4560.
Fuse Holder
Fuse Holder
Fuses
Snap
Connections