Welch Allyn Auriflush Ear Wash System - User Manual - Manual (Page 9)

8
Using the Auriflush System
Steps for Ear Cleaning
Always inspect the ear before attempting any ear cleaning procedures.
The presence of a perforated or compromised tympanic membrane
indicates it is unsafe to use the Auriflush System. Do not use this device if
the patient has a current or prior history of chronic middle ear infections.
Attaching the Tubing and Chamber
1. Connect the tubing to the chamber. Match the black connector to the black return
port on the side of the chamber. Match the blue connector to the blue irrigation port
on the lower side of the chamber.
2. To attach the chamber to the faucet, pull down the white plastic ring on the top of
the chamber, and then insert the chamber over the snap aerator on the faucet. When
the chamber is positioned, release the white plastic ring. The chamber is now
secure.
Attaching an Eartip
1. Line up the grooves on the side of the eartip with the corresponding indentations on
the handle interface. Verify that you are attaching the eartip with the tab facing
upwards.
2. Press firmly on the eartip until it is flush against the handle interface. You will feel a
slight snap when the eartip is in place.
Ear Cleaning
1. The use of sedatives, tranquilizers or general anesthetics may be indicated
depending on the temperment of the animal and the degree of pain present. For
routine cleaning in an otherwise non-fractious animal, the procedure is generally
well tolerated.
2. To reduce procedure time, use an ear cleaning solution or cerumenolytic, such as
Gent-L-Clens ® .
3. Initially, you may cover the patient with a cloth drape to eliminate splashing. Once
the technique of sealing the ear canal is mastered, this may not be necessary.
4. Begin to run water through the unit by first turning the cold water on completely.
Then gradually turn on the hot water until the water exiting the bottom of the
chamber feels close to body temperature.
5. Check the temperature of the irrigating water by looking at the thermal sensor while
depressing the water flow actuator. If the thermal sensor is blue, the irrigating water
is not warm enough. If the thermal sensor is white, the water temperature is at least
90° F and the procedure may begin. You must depress the actuator on the handle for
the temperature sensor to function correctly.
If the water is too cold, the patient may become dizzy or experience
vertigo. Please verify that the thermal indicator is white before proceeding
with the irrigation.
SPA-22413 Manual BC 12/13/01 6:34 PM Page 8