Welch Allyn 767 Diagnostic System - User Manual - Manual (Page 5)

1-1
Mounting Instructions
Fasten mounting plate to the wall with enclosed screws, making sure that the
screw hole flanges face away from the wall and the smooth surface of the
mounting plate is flush with the wall. Depending on the mounting surface,
alternative screws may be needed. With the flat side of the plate on the mounting
surface, level the plate as shown. Note that the plate should be mounted so that
the widest portion of the plate is horizontal (as shown). When mounting screws
are tightened, there will be a gap between the screw head and surface of the plate.
Mount the unit by fitting the round holes in the backplate over screw heads
on the wall mounting plate, then push downward on the unit to secure it to the
wall. This slides the tapered slots in the backplate over the shoulders in the
mounting plate. Plug into 230v, 50/60 Hz AC (240v, 50 Hz AC in Australia)
and unit is ready for use.
FLAT SIDE
SCREW HOLE
FLANGES
BACK PLATE
TO POWER