Welch Allyn Propaq 6.2X-8.4X/Propaq Encore 1.20-1.3X - Quick Reference Guide - Manual (Page 8)

6 Protocol Systems, Inc.
While this SpO
2
alarm holdoff is occurring at Acuity, the
10-second audio alarm holdoff at the bedside Propaq 100 is also
occurring as previously described (see “Propaq Audio Alarm
Holdoff with Acuity”). After the 10-second delay, the bedside
audio alarm occurs. Contact Protocol Systems Technical Support
for more information about this feature.
How to Change Power-On Default Settings
The power-on default settings for a Propaq Encore or Propaq 100
Series monitor are preset at the factory to the “Factory Default
Settings” listed in Appendix B of the
Propaq Reference Guide and
Propaq Encore Reference Guide.
However, you can change any of these power-on default settings.
Change Power-On Settings for Date, Decimal, ECG Filter,
and LCD Contrast
Whenever you change any of these settings, you also
immediately change the corresponding power-on default setting.
No other steps are needed. (The LCD contrast setting is only
available with the Propaq 100 Series LCD monitors.)
Software Versions
Propaq Encore 1.20-1.3X
Propaq 100 Series 7.XX-8.4X