Welch Allyn Euro-Med Rose Coated Electrosurgical Instructionumentation, Directions For Use and Sterilization - Quick Reference Guide - Manual

I. Turning the INSTRUMENT On
Flip the power switch on the handle
of the colposcope to the “ON” posi-
tion by pressing |. The video colpo-
scope will then automatically execute
an internal check of the optical sys-
tem by cycling from low to high mag-
nification ending in the low
magnification setting. NOTE: DUR-
ING THIS PROCESS, WHICH WILL
TAKE ABOUT 30 SECONDS, you
will not have the ability to use the
controls.
II. Re-starting the System
The colposcope must be turned off for 15 seconds prior to re-
starting the system. If the system is turned off for less the 15
seconds, the lamp will not re-ignite. If this occurs, turn the
system off and wait for 15 seconds prior to turning the sys-
tem on.
III. Focusing
To focus the video colposcope,
adjust either the exam table or
instrument to the desired height.
Position the video colposcope so
that the cervical image is centered
on the monitor. At this point the
image will most likely be blurry
and out of focus. To bring the
instrument into focus, move the
entire colposcope by slowly
advancing or withdrawing the
instrument, relative to the patient,
until the image comes into focus.
Once focus at low magnification is achieved, depress the
‘ZOOM +’ control until maximum magnification is obtained.
The monitor will again most likely show a blurry image. To
bring the image into focus, very slowly advance or withdraw
the instrument, relative to the patient, until the image is
sharp and in focus. Once this is achieved at high magnifica-
tion, depress the ‘ZOOM -’ control and return to a lower mag-
On/Off Power
Switch
Video Colposcope
Quick Reference
Guide
Focus
Zoom
Green Filter